Yehia Badr

Polycrystalline lithium-ammonium sulphate samples were subjected to X-ray diffraction analysis for determining the lattice parameters of the prepared mixed crystals. The compositions of the samples were determined using X-ray microanalysis. The Li0.5(NH4)0.5SO4 samples were irradiated with different doses of γ-radiation in order to investigate the effect of this ionizing radiation on the phase transition temperatures Tc1 and Tc2. The temperature dependence of the d.c. resistivity ρd.c. and dielectric constant ϵ of irradiated samples showed (i) a shift of Tc1 to higher temperatures; (ii) a shift of Tc2 to lower temperatures; and (iii) the appearance of a new anomaly near 128°C at moderately high γ-doses. The mechanisms giving rise to this behaviour are discussed.

Polycrystalline lithium-ammonium sulphate samples were subjected to X-ray diffraction analysis for determining the lattice parameters of the prepared mixed crystals. The compositions of the samples were determined using X-ray microanalysis. The Li0.5(NH4)0.5SO4 samples were irradiated with different doses of γ-radiation in order to investigate the effect of this ionizing radiation on the phase transition temperatures Tc1 and Tc2. The temperature dependence of the d.c. resistivity ρd.c. and dielectric constant ϵ of irradiated samples showed (i) a shift of Tc1 to higher temperatures; (ii) a shift of Tc2 to lower temperatures; and (iii) the appearance of a new anomaly near 128°C at moderately high γ-doses. The mechanisms giving rise to this behaviour are discussed.

Abstract In laser beam machining with oxygen gas, striations are formed on the cut surface due to the cyclic oxidization reaction, which is affected by the cutting conditions and the thermal properties of the workpiece. The formation of striations causes an increase in surface roughness. In order to reduce the surface roughness, we propose controlling the formation of striations by utilizing multi-DOF oscillation of the focus position of the laser. In this paper, we construct a laser machining system in which positioning control of the focus position is achieved by driving the focal lens. The effect of orbital oscillation of the laser focus position parallel to the top surface of the workpiece and vertical oscillation perpendicular to this surface on the formation of striations was evaluated by performing laser cutting tests on thick mild steel plates. The experimental results show that control of the formation of striations can be realized by choosing the appropriate oscillation conditions. The surface roughness with oscillation was less than half that without oscillation.